AB Night Vision RVM-14 Dual Articulating Bridge

AB Night Vision RVM-14 Bridge Mount will allow users to bridge two RVM-14’s together to be used a bino setup. The bridge arranges the RVM-14 in the same vertical orientation. The arms can also be easily removed for single mono use. Both the Arm and the Bridge are articulating.

NOTE: This bridge will only work with the RVM-14 as it uses a proprietary interface.

BRIDGE / ARM OPERATION:

To connect the Arm or Bridge to the monocular, first ensure that the Latch Screw is fully retracted by rotating it counterclockwise until it stops.

Slide the Mounting Shoe of the Arm or Bridge onto the Dovetail Mount of the Mono.

Engage the Latch Screw by turning it clockwise until it stops. Ensure that the Latch Screw is properly engaged by attempting to slide the Mounting Shoe. It should not move.

Remove the Arm or Bridge by retracting the Latch Screw fully counterclockwise and then sliding the Mounting Shoe off of the Dovetail Mount.

To adjust the pivot tension of the Arm or Bridge use a coin in either end of the Tension Bolt to tighten or loosen as desired.